Products
- Rear Urethane trailing arm bushings ( set of 4 )
- Front K&N Filter conversion with pipe. For use after battery has been moved. (81-83 )
- Shorten front strut housings and install struts and threaded collars
- Slot rear subframe for camber and toe adjustment
- Re-Enforce rear subframe arms and diff carrier.
- Good used Subframe with slotting and re-enforcement done.
- R4 Carbon Kevlar Racing Pads
- Steel Braided Brake Line Kit
- R4 Carbon Kevlar Racing Brake Shoes
- Steel Braided brake line set and hardware.
- BMW M10 ITB Package Basic Kit LESS ELECTRONICS !
- Electromotive TEC-S200 Package
- Haltech Sprint 500 Management package
- Complete Wide Band 02 Upgrade WITH Gauge
- Distributor Plug with o-ring
- Rear Ultimate Strut Tower Brace and Battery Relocation kit
- Combination package with Front and Rear Ultimate Braces
- Ultimate Spark Package 4 Cylinder for all M10. Specify Year !
- Bosch Red Coil
- Accel 8mm wire sets
- MSD-6A capacitive discharge ignition box
- MSD Tach Adapter
- Pertronix Mag Pick-up Electronic Ignition Conversion
- Rod Bearings
- Main Bearings with thrust washers
- Full Engine Gasket Set
- Intake or exhaust
- ARP Main Studs
- ARP Flywheel bolts
- Timing Belt
- Timing belt Idler
- Water pump
- Thermostat
- Clean, blast and pressure test
- 3 angle racing valve job with hand lap and back-cut
- Remove and replace valve guides
- Valve guides (each.)
- Surface head (Up to .040 off.)
- Adjust valve (labor only)
- Valve shims as needed (each)
- Grind camshafts ( in pairs only.)
- Street port.
- Race port.
- Race prep crankshaft:
- Race prep Con rods. Set of 4
- Flywheel lightening
- Remove secondary butterfly set
- Short Block Assemblies
- Long Block assemblies
- High Heat coating on pistons add